Starting Warm Engine - Echo SRM-260U Operator's Manual

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not depress throttle trigger to wide open position.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Primer
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
NOTE
Lightly place knee on drive shaft to stabilize unit during starting. Do
not apply excessive downward force or damage to unit can occur.
3. Recoil Starter
Lay the unit on a flat, clear area and pull the recoil starter handle
(D) until the engine fires.
G
RASS
DANGER
T /B
RIMMER RUSH
O '
PERATOR S
A
C
D
C
UTTER
19
M
ANUAL