Operation And Menu Program; Receiver And Tv Set-Up - EchoStar DSB-800 2Ci User Manual

6. Operation and Menu Program

A. Receiver and TV set-up
Installation
Check the
To get the most out of the EchoStar DSB-800 2CI it should be correctly installed, the dish should be
optimally aligned and the mechanical limit switched on the dish should be set properly. Press
remote control unit (RCU) or press
The receiver is supplied with factory setting and will start up with the "Language Setting" menu. For more
information on the "Language Setting" menu, please see page 10. Please follow the steps outlined below to
properly install the EchoStar DSB-800 2CI.
LNB Setting
Select the "LNB Setting" menu in the "Installation"
menu using the
Select the LNB type which conforms to your LNB usi
ng the keys.
Other parameter values should be changed
manually according to your LNB type.
Press the OK key to confirm your selection.
Program Satellites
Refer to the Signal Quality bar and the Signal Level bar
at the bottom of the screen. It is recommended that the si
gnal is at the Medium level or higher.
If it is not , please adjust your satellite dish.
This menu is to align your dish to the selected satellite.
After setting the parameters, press the OK key to store th
e parameter values and Start Search(Press OK) to search
the channels of the transponder you want.
If you are unable to get any signal quality, please check the LNB Setting to ensure you have selected the corr
ect LNB and switch settings.
/I on the front panel of the EchoStar DSB-800 2CI.
keys.
LNB Setting
1
2 LNB Freq.Low
LNB Frq. High
3
4 DiSEqC
5
DiSEqC Port
6 Polarity Control
7
LNB Freq. Band Control
8
0/22kHz Control
9 LNB Power
i
Program Satellite
1
2 LNB Type
3
TP/Polar
4
Symbol Rate
5
Position
6 Step Move
7
Search type
8 8
Start Search(Press OK)
Signal Level
Signal Quality
i
9
on the
?
LNB Type Index (1..8) Type 1
5150
5150
DiSEqC 1..4
1
13/18V
0/22kHz
Off
On
?
Satellite 028.2° E ASTRA2
Type1
11478/H
30000
Set
E
Auto Search
52%
63%
?
?
W