EchoStar DSB-1200 Viaccess User Manual page 24

Familiarization
Section 4
2.2.1. SYSTEM SETUP MENU
This sub-menu allows you to customize the system setup to match your installation. Note that
the menu page is dynamic which means that it changes with the selections you make. You
can customize:
2.2.2. FIXED DISH SETUP
This sub-menu allows you to customize the system setup to add an additional fixed dish into
your DiSEcQ1.2 configuration. Note that the menu page is dynamic which means that it
changes with the selections you make. You can customize:
Page 4 - 8
System
To set the dish type you use.
LNBs
To set the amount of LNBs you have installed.
Polarity
To set the device that controls the signal polarity.
Switch
To set the switch type which you use to control the
dish installation (if used).
LNB1
To set the LNB type(s) you use.
Program Satellites (DiSEqC1.2 only)
To confirm the selections and go to next menu.
Satellite (fixed only)
To set the satellite you want to scan for the LNB.
Check Signal (fixed only)
To confirm the selections and go to next menu.
LNB Power (SMATV only)
To select the distribution type (cable=Off, IF=On).
Symbol Rate 1-4 (SMATV only)
To set the symbol rates you want to scan. You can
search four symbol rates simultaneously in one
search. Repeat the session if you want to scan for
more symbol rates.
Search Channels (SMATV only)
To confirm the selections you made and advance
to the Search Channels page.
LNBs
To set the amount of LNBs you have installed.
Polarity
To set the device that controls the signal polarity.
Switch
To set the switch type which you use to control the
dish installation.
LNB1
To set the LNB type(s) you use.
Satellite
To set the satellite you want to scan for the LNB.
Check Signal
To confirm the selections you made and advance
to the Check Signal page.
EchoStar DSB-1200 Viaccess