Advertisement
Available languages
Available languages
● OPERATING INSTRUCTIONS ●
W
i-Fi MODULE SETTING UP
NET LED
NET LED fl ashing indicates that the Wi-Fi module is communicating with the
router.
When it doesnʼt connect well
Check the following, and pair the Wi-Fi module and the Router according to
Selecting a mode.
• Make sure that the communication distance is not too far between the Wi-Fi
module and the Router.
• Make sure that the Router uses WPA2-AES encryption.
• Make sure that the number of connected devices to the Router does not exceed
EN
the limit.
• Make sure that DHCP is enabled, or check IP address setting of the Wi-Fi
module.
• Check DNS settings of the Router, or check DNS address of the Wi-Fi module.
• Check if the Router is connected to Internet.
• Set up the Wi-Fi module after operating the air conditioner using the wireless
remote controller at least once.
If the connection fails even after checking the above, set up the Wi-Fi module
and the router again by the following method.
• Hold down the Temperature
• Select "_ 2" by pressing Temperature
• Point the remote controller toward the indoor unit and press the
• The indoor unit beeps 3 times when resetting is complete.
[About trademarks]
• WPS is the connection via Wi-Fi Protected Setup.
• "Wi-Fi®", "Wi-Fi Protected Setup™", "WPA2™" are trademarks or registered
trademarks of the Wi-Fi Alliance.
For Declaration of Conformity and MELCloud User Manual, please go to
the website below.
http://www.melcloud.com/Support
The Wi-Fi module uses Open Source Software. To view the Open Source
software licence(s), please go to the following website whilst connected to
the Wi-Fi module during the Access Point mode.
http://192.168.11.1/license
EN-17
for 5 seconds.
and
.
Note:
• Ensure that the Router supports the WPA2-AES encryption setting before
starting the Wi-Fi module setup.
• The End user should read and accept the terms and conditions of the Wi-Fi
service before using this Wi-Fi module.
• To complete connection of this Wi-Fi module to the Wi-Fi service, the Router
may be required.
• This Wi-Fi module will not commence transmission of any operational data
from the system until the End user registers and accepts the terms and con-
ditions of the Wi-Fi service.
• This Wi-Fi module should not be installed and connected to any Mitsubishi
Electric system which is to provide application critical cooling or heating.
• Please write down the information regarding the Wi-Fi module setting on the
last page of this manual, when you set up this Wi-Fi module.
• At the time of relocation or disposal, reset the Wi-Fi module to the factory
default.
Mitsubishi Electric's Wi-Fi module is designed for communication to
Mitsubishi Electric's MELCloud Wi-Fi service.
Mitsubishi Electric is not responsible for any (i) underperformance of a
system or any product;
(ii) system or product fault; or (iii) loss or damage to any system or product;
which is caused by or arises from connection to and/or use of any third
party Wi-Fi module or any third party Wi-Fi service with Mitsubishi Electric
equipment.
For the latest information regarding MELCloud from Mitsubishi Electric
Corporation, please visit www.melcloud.com.
.
Advertisement
