Advertisement
Available languages
Available languages
● OPERATING INSTRUCTIONS ●
A
IRFLOW CONTROL MODE
EN
Airfl ow Control mode offers air conditioning according to a location of
an occupant in a room detected by i-see Sensor.
1
Press
during COOL, DRY, HEAT or AUTO
mode to activate the AIRFLOW CONTROL mode. This
mode is only available when the i-see control mode is
effective.
2
Each press of
in the following order:
(INDIRECT)
(INDIRECT) : An occupant will be less exposed to
(DIRECT)
(EVEN)
• Horizontal and vertical airflow directions will be automatically selected.
• When more than a couple of people are in a room, the AIRFLOW
CONTROL mode may work less effectively.
• If you still feel uncomfortable with the air direction determined by the
INDIRECT mode, adjust the air direction manually.
• When you move to a new house or rearrange the room, hold down
for 5 seconds during operation. The indoor unit beeps twice
and starts to learn the area where an occupant spend most of the time
in the new or rearranged room. (This operation cannot be performed
when the timer is set.)
Cancelling the i-see control mode automatically can-
cels the AIRFLOW CONTROL mode.
• The AIRFLOW CONTROL mode is also cancelled when the VANE or
WIDE VANE buttons is pressed.
EN-9
changes AIRFLOW CONTROL
(DIRECT)
(EVEN)
(OFF)
direct airfl ow.
: Mainly the vicinity of an occupant will
be air-conditioned.
: The unit learns the area where an
occupant spend most of the time,
and evens out the temperature of
that area.
Page 8
A
BSENCE DETECTION
This function automatically changes the operation to No occupancy
energy-saving mode or No occupancy Auto-OFF mode when nobody
is in the room.
1
To activate this No occupancy energy-saving mode,
press
until
appears on the operation display of
the remote controller.
2
To activate this No occupancy Auto-OFF mode, press
until
appears on the operation display of the
remote controller.
Press
again to cancel the ABSENCE DETEC-
TION.
No
occupancy
detected
About
About 1 HR.
10 min.
Normal
Energy-
Saving energy
saving
mode
Normal
Auto-OFF
Saving energy
mode
• Even if the unit is turned OFF due to No occupancy Auto-OFF mode,
the display of the remote controller remains to indicate the unit is in
operation. Press
then press
• When OFF timer is set, a priority is given to OFF timer.
• The unit will not be turned off if no one is detected during normal
operation mode, even though No occupancy Auto-OFF mode is acti-
vated.
Cancel
Occupancy
detected
Normal
Saving more
Turn OFF
again to restart operation.
Advertisement
