Advertisement
Available languages
Available languages
W
i-Fi MODULE SETTING UP
Setting up in Access Point mode
Complete the setting up in the Access Point mode within 10 minutes.
To enter the mode
• Hold down the Temperature
for 5 seconds.
• Select "¯ 1" by pressing Temperature
as shown on the right.
• Point the remote controller toward the indoor
unit and press the
.
1
Connect your smartphone to the air conditioner.
Make sure that the LED indication is as shown below.
On the Wi-Fi Setting Screen on your smartphone, select SSID and enter
KEY, which are printed on the information label.
Connecting
MAC:
XXXXXXXXXXXX
ID:
XXXXXXXXXX
SSID:
SSID:
ME-XXXXXXXXXX
ME-XXXXXXXXXX
KEY:
KEY:
XXXXXXXXXXXX
XXXXXXXXXXXX
E.O.
SW
Wi-Fi module
Other
Smartphone
Note:
• Check Wi-Fi setting of your smartphone if SSID does not appear on it.
• Enter KEY again if SSID appears on your smartphone, but it cannot connect
to the Wi-Fi module.
• The LED indication does not change or fl ashes 5 times if connection fails. In
that case, reset connection and set up the Wi-Fi module and the router again.
2
Access URL (http://192.168.11.1/network) by any of the
following methods to display the setting screen.
• Scan the matrix barcode on the information label.
• Type the URL (http://192.168.11.1/network) in the web browser.
Information label
MAC:
XXXXXXXXXXXX
ID:
XXXXXXXXXX
SSID:
ME-XXXXXXXXXX
KEY:
XXXXXXXXXXXX
E.O.
Other
SW
Wi-Fi module
Access Point mode
and
The LED lights up for 3
seconds then fl ashes once.
A beep sounds as the LED
fl ashes. This series of actions
is repeated.
3
Register the information of the Router on the air condi-
tioner.
In the displayed window, select Dynamic in DHCP (*1)
and enter the information of Router, then tap the Sub-
mit button.
(*1)
Router
Note:
• If you want to use Static, select Static in DHCP (*1) and enter the information
of Router and network, then tap the Submit button.
• LED indication will return to initial state, if the connection fails.
• LED fl ashing and beep sounds will stop when the connection is completed.
4
LED indication will be as shown below when connec-
tion between the Router and Wi-Fi module is complet-
ed and connection to MELCloud starts.
Connected
Connecting
Note:
It may take several minutes to show the indication above.
The LED indication does not change or fl ashes 5 times if connection fails.
In that case, reset connection and set up the Wi-Fi module and the router again.
Connecting
Connecting
MELCloud
The LED lights up for 5 seconds and
then a beep sounds for 1 second.
EN-16
EN
Advertisement
