TRUE
tmw
INSTALLATION
OWNERSHIP
To ensure that your unit works properly from the first day, it must
be installed properly. We highly recommend a trained refrigeration
mechanic and electrician install your TRUE equipment. The cost of a
professional installation is money well spent.
Before you start to install your TRUE unit, carefully inspect it for
freight damage. If damage is discovered, immediately file a claim with
the delivery freight carrier.
TRUE is not responsible for damage incurred during shipment.
UNCRATING
TOOLS REQUIRED
•
Adjustable Wrench
•
Phillips Screwdriver
•
Level
The following procedure is recommended for uncrating the unit:
A. Remove the outer packaging by pulling tri-wall nails from skid.
Remove (4) cardboard corner pads and dust cover.
B.
Inspect for concealed damage. Again, immediately file a claim
with the freight carrier if there is damage.
C. Move your unit as close to the final location as possible
before removing the wooden skid.
NOTE: KEYS FOR COOLERS WITH DOOR LOCKS
ARE LOCATED IN WARRANTY PACKETS.
3
ELECTRIC INSTALLATION & SAFETY
INFORMATION
•
If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service
agent.
•
Lamps must be replaced by identical lamps only.
•
Appliance tested according to the climate classes 5 and 7
temperature and relative humidity.
ELECTRICAL INSTRUCTIONS
A. Before your new unit is connected to a power supply, check the
incoming voltage with a voltmeter. If anything less than 100% of
the rated voltage for operation is noted, correct immediately.
B.
All units are equipped with a service cord, and must be
powered at proper operating voltage at all times. Refer to
cabinet data plate for this voltage.
TRUE RECOMMENDS THAT A SOLE USE CIRCUIT BE
DEDICATED FOR THE UNIT.
WARNING: Compressor warranties are void if compressor burns
out due to low voltage.
WARNING: Power supply cord ground should not be removed!
WARNING: Do not use electrical appliances inside the food
storage compartments of the appliances unless they are of the type
recommended by the manufacturer.
NOTE: To reference wiring diagram, remove front louvered grill,
wiring diagram is positioned on the inside cabinet wall.
.
.
www
truemfg
com