Table of Contents
Advertisement
D. Configuring K-1900-8-IP VLAN Settings
Step 1.
Click on the "VLAN" tab
Step 2.
Disable or enable VLAN tagging by setting the value of "VLAN Tagging".
Step 3.
Set the VLAN tag ID by selecting an integer (1 to 4094) in "ID for all packets".
Set the Priority Code Point (PCP) value for all not SIP and RTP packets in the "PCP for all packets" input (0 is default, priorities are
Step 4.
from low to high: 0, 1, 2, 3, 4, 5, 6, 7). Set the "PCP for SIP packets" (3 is default). Set the "PCP for RTP packets" (5 is default).
E. Manually Resetting the Security Code to Enter Programming
Step 1.
Power down the K-1900-8-IP phone by disconnecting the LAN Cable (RJ45 plug).
Step 2.
Take the handset offhook, then reconnect the LAN Cable (RJ45 plug).
8-12 seconds after connecting the LAN Cable you should hear 2 beeps in the handset. Go back on-hook within 6 seconds and you
Step 3.
should hear 2 more beeps.
Step 4.
The security code is now reset to 845464 (factory default).
Step 5.
You can now enter programming by following the steps in section B above.
F. Manually Resetting All Network Parameters to Factory Default
Step 1. Power down the K-1900-8-IP phone by disconnecting the LAN Cable (RJ45 plug).
Step 2. Take the handset offhook, then reconnect the LAN Cable (RJ45 plug).
8-12 seconds after connecting the LAN Cable you should hear 2 beeps in the handset. 6 seconds later you should hear 4 beeps, go
Step 3.
back on-hook within 6 seconds*. Unit will reset and 2 beeps will be heard in approximately 7 seconds.
Step 4. You can now enter programming by following the steps in section B above.
*Note: if you do not go back on-hook within 6 seconds, the handset will continue to beep until back on-hook. This indicates an error and network
parameters will remain unchanged.
9
Advertisement
Table of Contents
