Viking K-1900-812L-IP Product Manual page 14

Keyless Entry Code and Proximity Card logging can be set to Log Errors. With Log Errors selected, the K-1900-8-IP
Series phone will not only log all valid Keyless Entry Code and Proximity Card entries, but also log any errors, incorrect
codes, or non-valid card reads.
Keyless Entry Code and Proximity Card logging can also be set to Live Logging. With Live logging selected and the
K-1900-8-IP Series programming software open and connected to a unit, each Keyless Entry Code entered or Proximity
Card read will immediately open the Event Log screen.
11. Security Code
The security code allows the user/installer to program the K-1900-8-IP Series phone. It is recommended that the factory
set security code be changed. Factory Setting: 845464
Note: The security code must be 6 digits and cannot include a , or a #.
12. Access Code
The access code comes into play when a tenant calls the K-1900-8-IP Series phone and a visitor lifts the handset to
answer the call or the K-1900-8-IP Series phone automatically answers the call (see Inbound Call Mode). It is a 1 to
6 digit code (can not contain "," or "#") that the tenant must dial before they are allowed to operate the door strike
relays, as extra security on inbound calls. Once a tenant has entered the correct access code, 2 beeps are heard and
the user can now enter any "Remote Access Operation Commands" (see page 22). The access code can be disabled
if this basic security is not required. Factory Setting: 123456
13. Wiegand Direction
Wiegand Direction allows you to decide if the 26 bit Wiegand connection will be used as an input or an output. The default
setting for direction is "Inbound" and this is the correct setting if you intend to connect a card reader or Wiegand keypad
device to the wiegand connections.
When the direction is set to "outbound", the 26 bit Wiegand connections become an output and can be connected to the
card reader input on the access control system. Unprogrammed keyless entry codes dialed by the user on the keypad are
then sent over the Wiegand output. When the user dials "#" plus a entry code that is not programmed in the Entry Code
Database, the code dialed by the user is sent over the Weigand output along with the facility code selected. Since Wiegand
data limits the entry code to 65535 maximum, "#" plus entry codes higher than 65535 are not sent over the Wiegand
output. When the user dials "#" plus a valid keyless entry code that is programmed in the Entry Code Database, the code
dialed by the user is not sent over the Wiegand output and the Local / External relay is activated.
14. Select Time Zone
When using date and time logged events or setting the access date and times of keyless codes or proximity cards in
the Entry Code Database, you must program the unit to your time zone. Example: You are installing the K-1900-8-IP
Series phone in the Central standard time zone: Select (UTC - 06:00) CST, which is 6 hours behind Coordinated
Universal Time (UTC). Factory Setting: CST
15. Daylight Savings
The Daylight Savings Time programming can be enabled or disabled and can be programmed to start on any Sunday
in March and stopped on any Sunday in November. Currently, daylight saving time starts on the second Sunday in
March and ends on the first Sunday in November, with the time changes taking place at 2:00AM local time.
Factory Setting: Enabled
14