Led Light Rail Installation - Lippert Components Solera Installation Manual

7.
Repeat this process for the other side of awning assembly.
NoTe: Four rivets with 3/16" grip range can be used in place of the two middle and two lower screws on
laminated walls.
8.
Take the LED power wire that is already fed through the idler leg and connect to the desired power
wire from the coach.
NoTe: Be sure the black wire is connected to a ground and the red wire is connected to a 3 amp max fuse
and then a power source from the coach.
NoTe: Extend and retract the awning one or two times to ensure that it is square before setting the screws.
9. Attach fabric cord to awning rail with two screws #6-20 x 1/2" hex to prevent lateral movement.
10. Seal all wall penetrations to protect against water intrusion.
NoTe: All screws/rivets supporting the awning assembly MUST have a backer within the structure of the
wall of the coach.
NoTe: Solera® awnings under 21' in length Do NoT require the use of a cradle.

LeD Light Rail Installation

NoTe: Solera® Power Awning MUST be installed prior to LED Light Rail installation.
1. Mount the LED light rail track (Fig. 7B) directly below the awning rail (Fig. 7A) and secure to the side of
the coach.
2.
Route the light wire over the top of the awning mount leg and run the light wire down through the leg
in the same manner as the motor wire (Fig. 8).
3.
Cut wire to desired length and connect to the coach wiring, making sure to connect the red wire on
the light side to the power wire on the coach side.
NoTe: The LED light rail MUST be wired through a 3 amp (maximum) fused circuit.
4.
Connect the black wire on the light to the ground on the coach side.
5. Make sure to seal the light track where it is screwed to the wall and where the light wire connects to
the coach wire.
6.
Turn the light on to confirm it illuminates.
A
B
Rev: 02.25.2016
Fig. 7
Page 3
Fig. 8
Solera Power Awning with LED Lights Installation Manual