Securing The Child - Diono Everett NXT Instruction Manual

SECURING THE CHILD

WARNING! Use ONLY the lap and shoulder belt system when restraining
the child in this booster seat. DO NOT
1. Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the
vehicle seat back. A gap is acceptable as long as
the head support is touching the vehicle seat
back or head rest.
2. Properly position child: sitting upright and seated
all the way back in the booster seat.
3. Adjust head support to proper height: The
shoulder belt guide should be slightly above the
child's shoulders (at least 1 cm).
4. Feed the vehicle's diagonal shoulder belt
portion of the seat belt through the
shoulder belt guide into the side of the seat
opposite the seat belt buckle.
20
1-855-463-4666
use lap belt only.
RED
1cm 1cm
RED
5. Fasten vehicle seat belt across child. The lap
portion of the seat belt should rest within both
lower belt guides. The diagonal shoulder belt
portion should route inside the lower belt guide
closest to the buckle and over child's shoulder.
6. Make sure the vehicle seat belt is not twisted and
lays flat across child's lap, torso and shoulder.
7. Tighten the seat belt by pulling the diagonal
shoulder belt portion in the direction of the
arrows.
8. Confirm seat belt buckle is in correct position.
IMPORTANT: The Vehicle Shoulder Belt MUST route completely through
the RED shoulder belt guide and not fall off the child's shoulder.
IMPORTANT: DO NOT position the Vehicle Lap Belt over the armrest.
It MUST pass through the lower belt guide.
IMPORTANT: When using the diagonal portion of the seat belt, it should
lay over the shoulder and should NOT be touching the child's neck.
SECURING THE CHILD
diono.com
21