Table of Contents
Advertisement
2.10 TROUBLESHOOTING CHECK LIST FOR ADAPTERS
• Make sure the adapter is installed and properly seated in the
PC chassis connector.
• On the adapter, if the coax port is used it is necessary to have a
T and terminator attached to it.
• If the adapter does not initialize, verify that the bus slot is
operational by swapping the adapter with an adapter that you
know is functioning.
• Try swapping the adapter with a known working adapter.
• The interrupt, I/O address or memory parameters could be
conflicting with another adapter. Use a program like "Check-
It" to determine what settings are currently in use by other
adapters.
• Verify that the cable is attached to the media port that you
want to use.
• If a connection to a server or another host cannot be
maintained, check the cable first with a TDR or pair scanner.
After verifying the cable, check the device that you are trying
to communicate with. Verify that you can ping it or that other
clients can contact it.
2.11 SOFTWARE CHECK LIST
• Cabletron supplies different drivers for use with different
operating systems. Make sure that you are using the correct
driver and that the I/O hardware jumper agrees with the
software I/O setting that you selected.
• If you are using Novell NetWare, Cabletron supplies a direct
IPX and a packet driver IPX. Make sure you are using the
correct IPX.COM file.
INSTALLATION
Page 2-15
Advertisement
Table of Contents
