Advertisement
SPECIFIC CORDLESS STAPLER
SAFETY INSTRUCTIONS
Operational Safety Instructions
1) Secure your workpiece. Your workpiece should be clamped with clamping devices or in a vise, this
is much safer than securing your workpiece by hand.
2) Before starting any work on the stapler itself (changing staples, maintenance), as well as when in
storage or in transport, remove the battery from the stapler housing.
3) Keep your fingers away from the staple/nail discharge area, danger of accidental injury.
4) Never point this cordless stapler at any person or aminals. Staples or nails fired from a short
distance can cause conciderable injuries.
5) Do not use this cordless stapler to fasten electrical wiring. Accidental contact with electrical lines
can lead to fire and electric shock.
6) Check walls, ceilings, floors, roofing carefully to avoid possible electric shock, gas leakage,
explosion caused by stapling into live wires, conduits or gas pipes.
7) Only use recommended staples/brad nails as specified in this manual. The use of any other
staples/brad nails may cause the tool to malfunction.
8) Do not operate the tool without staples/brad nails. This shortens the service life of the tool.
9) Never actuate the trigger and the safety lever at the same time unless you are prepared to staple
a workpiece. Never tamper with the safety lever, always make sure it functions properly. If this
safety lever does not function properly, do not use the tool, have it repaired before using again.
Battery & Charger Safety Instructions
1) NEVER open the battery. Danger of short-circuiting.
2) Protect the battery against heat, continuous sun exposure and fire. Risk of explosion!
3) Keep the battery charger and adaptor away from rain or moisture. Penetration of water in the
battery charger increases the risk of electric shock.
4) Keep the battery charger and adaptor clean.
5) Always remove the battery from the tool before loading staples, making an adjustment, inspection,
maintenance or after the operation is done.
6) Do not charge the battery when temperature is below 10
7) Do not store tool or battery in temperatures exceeding 50
8) No not allow anything to cover the charger vents.
9) Do not store your battery in a container with other metal objects such as nails, screws, etc.
10) Never incinerate the battery even if it is severely damaged or worn out. Risk of explosion. Dispose
of used battery at your local recycling and/or disposal centre.
0
C (50
0
F) or above 40
0
C (104
0
F).
0
C (122
0
F).
GETTING TO KNOW
YOUR CORDLESS STAPLER
Force selector knob (depth setting)
Staple/Brad nail view finder
Safety
Staple/Brad nail
lever
discharge area
SPECIFICATIONS
Model ....................................................................................................................................8150CT
Voltage ........................................................................................................................................4.8V
Battery type ....................................................................................................................1.3Ah Ni-Mh
Staple size ....................................................................................................................20 Ga. x 3/8"
Staple size range ..............................................................................................................1/4" - 9/16"
Brad nail size ..........................................................................................................................18 Ga.
Brad nail range ..................................................................................................................3/8" - 5/8"
Magazine capacity ..........................................................................................100 staples/brad nails
Discharge rate ........................................................................................................................30/min
4.8V Rechargeable
Ni-Mh battery
Trigger
Magazine latch
Magazine
Charger and charger adaptor
Advertisement
