Installation - Wired Doorbell - HAMPTON BAY HB-7611-02 Use And Care Manual

Installation - Wired Doorbell

Verifying the transformer
1
power rating
Power must be supplied from a 16 volt AC, 10 or 15 watt
transformer.
WARNING: This doorbell requires a low voltage electrical
connection. Do not connect directly to 120V AC.
NOTE: DO NOT install batteries if connecting doorbell to
transformer wires.
2
Removing the existing doorbell
Remove the cover from the existing doorbell
and label all wires with masking tape before
disconnecting:
"F" - Front door push button wire
"T" - Transformer wire
"R" - Rear door push button wire (if
applicable)
Disconnect all wires from existing doorbell and
remove doorbell from mounting surface.
3
Rotating the cover pin
Before mounting the doorbell base (B) to the
wall, turn the doorbell base (B) vertically or
horizontally (depending upon the doorbell
cover (A)) and slide the cover pin out of the
doorbell base (B).
Turn the pin over and slide the cover pin into
the doorbell base (B).
4
Mounting the doorbell base
Route the wires through the wire entrance hole
in the doorbell base (B).
Using the "UP" arrow indicator, place the
doorbell base (B) against the wall and mark
the four screw hole locations.
Drill four 7/32 in. pilot holes and insert wall
anchors (BB).
Attach the doorbell base (B) to the mounting
surface using the four screws (AA) and tighten
securely.
T
O N
F R
S
A N
T R
A R
R E
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS REAR
1 SECOND.
5
Please contact 1-844-760-3644 for further assistance.
B
AA
B
HAMPTONBAY.com