Operation At High Altitude - Firman H07552 Owner's Manual

(included) to the LPG hose connector (inlet) on the
control panel of the generator. Tighten the nut with
19 mm or adjustable wrench. Remove the safety
plug or cap from the cylinder valve.
Attach the other end of the LPG regulator/hose
assembly to the cylinder valve. Tighten the nut by
hand clockwise to a positive stop. Do not use a
wrench to tighten. Use of wrench may damage quick
closing coupling nut and result in a hazardous
condition.
Do not use tape or any type sealant to seal the LPG
hose connections.
Do not install or replace the LPG cylinder near open flames, pilot lights, or sparking electrical
pressure is highly flammable and equipment such as power tools, welders and can cause a fire or explosion
if ignited.
grinders.
•
LPG has a distinctive odor to help detect
leaks.
•
Do not allow children to tamper or play with
English
You must use the supplied regulator/hose
assembly for safe operation.
Always position the cylinder so the connection
between the valve and the regulator won't cause
bends or kinks in the hose.
Spray a soapy water solution (one part liquid
detergent and one part water) to check all
connections for leaks before attempting to use
generator. Slowly open the cylinder valve. A leak
exists if bubbles appear or grow larger in size or
number. This must be corrected before using the
generator. Contact your local Authorized Service
Facility for assistance. Do not attempt to make
repairs yourself.
Do not check for leaks with a lighted match or
flame.
Do not light or smoke cigarettes.
Check the fuel system periodically for leaks or
CAUTION
•
LPG is heavier than air and can accumulate in
confined spaces and low places in the event of a
leak.

Operation at High Altitude

At altitudes over 5,000 feet(1524 meters), a
minimum 85 octane / 85 AKI (89 RON) gasoline
signs of damages.
•
LPG under
potential
Customer Service: 1-844-FIRMAN1Page 21