Table of Contents
Advertisement
Qualified electrician:
Due to the electrician's specialised training, know-how,
experience and knowledge of pertinent standards and
regulations the electrician is in a position to work on the
electrical systems, and autonomously identify and avoid
potential hazards.
Specialist staff:
As a result of specialist training, expertise, experience
and skills in terms of the relevant standards and regulati-
ons, specialist staff is able to complete the tasks they are
entrusted with and independently identify hazards and
avert risks.
Manufacturer:
Certain work must be carried out by manufacturer spe-
cialist staff only. Other staff is not permitted to carry out
this work. Contact our customer service to have the work
carried out.
2.4 Personal protective equipment
Personal protective equipment is intended to protect the
health and safety of persons at work. Staff must wear the
personal protective equipment indicated in individual
sections of these operating instructions when carrying
out the different tasks on the machine.
The personal protective equipment is described in the
following section:
Hearing protection
Hearing protection protects the ears against hearing
damage caused by noise.
Eye protection
Protective glasses protect the eyes against projected
parts and splashes of liquid.
Protective gloves
Protective gloves protect the hands from compo-
nents with sharp objects as well as friction, abrasion,
and deep-cut injuries.
Protection of face
The face protection prevent the face of objects flying
around.
SAA Series | Version 1.06
Safety shoes
Safety shoes protect feet from pinching, falling parts
and slipping on slippery surfaces.
Protective clothing
Protective work clothing means tight-fitting clothing
with low tear resistance.
2.5 Safety labels on the Chip Extraction Unit
The following safety labels and instructions are attached
to the Chip Extraction Unit s (Fig. 1) and must be
observed.
1
2
Fig. 1: Safety labels:1 Warning of dangerous electrical voltage |
2 Safety instructions
If safety labels on the machine are damaged or missing,
this can cause errors, personal injury and material da-
mage. The safety symbols attached to the machine must
not be removed. Damaged safety symbols must be re-
placed immediately.
As soon as the signs are not clearly visible and compre-
hensible at first glance, the machine must be stopped
until new signs have been attached.
Safety
5
Advertisement
Table of Contents
