Table of Contents
Advertisement
Installation and connection
7.2 Set up the Chip Extraction Unit
Place the machine on a stable, level ground. The
distance to the wall should be min. 800 mm.
Check the data of electric connection.
The ambient temperature must be within -10 ° to + 50 °
Celsius, max. air humidity 90%.
Don´t expose the machine to moisture, rain or snow.
Carry out maintenance and servicing regularly.
ATTENTION!
Risk of injury through a non-stable adjusted machine!
Check the stability of the machine always after instal-
lation or maintenance.
Wear the safety gloves!
Wear the protective clothing!
Wear the safety shoes!
7.3 Initial operation the Chip Extraction Unit
Step 1: Check whether of the extraction hose on to Ex-
traction Unit and the extraction adapter on the
woodworking machine are connected.
Step 2: Check whether the chip bag is good fixed.
Step 3: Switch on first the Chip Extraction Unit and then
only the woodworking machine.
Step 4: Before switch off the extraction unit, first switch
off the woodworking machine.
Step 5: Inspect regularly the chip bag and empty it
if full is.
Step 6: Before operating the on / off switch, make sure
that the filter bag is good fixed.
10
7.4 Electrical connection
ATTENTION!
Observed on the good grounding of
the Extraction Unit!
Static electricity charge leads to
- Deposition of abrasive dust
- Rapid corrosion of the moving parts.
- Spark formation by discharge with explosion
hazard!
ATTENTION!
Danger to life due to electrical
shock! !
Danger of live through electric shock by contact with
live power components!
- The Chip Extraction Unit may connected only from
Qualified electrician.
- Work on the electrical system must execute only
from Qualified electrician.
In the follow Steps the Chip Extraction Unit can con-
nected to the electricity network:
Step 1: The Chip Extraction Unit must be off.
Step 2: The Chip Extraction Unit (SAA 2003 und SAA
3003 Model) connect on the 400 V / 3-phase
connection.
Step 3: Check, whether all protective devices are
mounted.
Step 4: Switch on the Chip Extraction Unit.
Step 5: Check, whether the direction of rotation of the motor
is correct.
SAA Series | Version 1.06
Advertisement
Table of Contents
