Troubleshooting Guide - Guardian Pureguardian H7560 Use & Care Instructions Manual

TROUbLESHOOTING GUIDE

pRObLEM SOLUTION
Water vapor and humidity are Power Plug: Unplug and then try again.
not produced.
Power Failure: When the power is returned, try again.
Tank Installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-10)
Air blows but water vapor is Excessive Water: Remove a certain amount of water from
not produced. the tank.
The desired humidity is lower than the current temperature:
Increase the desired humidity.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-10)
If you use hard water, replace with softer water.
Humidity level is low. The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-10)
The water in the unit is too cold: Replace with cool, but not
cold water.
Damage on the ultrasonic disk: Contact Customer Service
1.866.603.5900
Warm humidity is not produced. It may take 10-15 minutes before warm humidity is created. The
mist may not feel warm due to the fact it is so fine and is cooled
rather quickly from the air in your home. Test by either feeling the
base of the unit which should be warm to the touch or by allowing
the unit to run for approximately 30 minutes on warm setting in
a closed 200 sq. foot room or smaller. The room should feel
moderately warmer if the unit is working properly.
The humidity has a bad smell. Poor maintenance or dirty water: Clean the product thoroughly, and
fill it with fresh water. (see pg. E-10)
White dust is forming on Hard water may deposit a certain amount of dust. Dust in the air
nearby furniture. also settles because of added humidity in the room. Use distilled
water if this becomes a nuisance.
* Decalcification Filter (FLTDC20) available at
www.guardiantechnologies.com or through Customer Service
1.866.603.5900.
Unit has stopped working. No or low water. Unplug unit and refill tank.
The humidifier is equipped with a thermal safety device that will
display "OH" when activated. If it enters a mode showing "OH"
it will automatically restart when cooled down. If the unit does
not automatically restart, then allow the unit to cool and cycle the
power button to reset and start the humidifier.
Important: If the unit continues to display "OH" or shut down, there
may be an abnormal condition and the unit may need service. Call
Customer Service at 1-800-603-5900.
Water is accumulating outside of unit Saturation of humidity. Lower mist control setting.
or area surrounding unit.
Unit not level and water is accumulating. Unplug and place on
level surface. Point spray away from objects. Raise unit on a
water-resistant level surface 2-3 feet off of floor.
E-12
TROUbLESHOOTING GUIDE
pRObLEM SOLUTION
Water dripping when refilling. Water remaining on bottom of tank. Wipe tank or tilt to drain
before transporting.
Cap not tight. Twist to firmly secure cap after filling tank with water.
Increased noise level. Unit must be placed on a flat, level, hard surface. Make sure it is
NOT placed on a soft or absorbent surface.
Humidifier display not reaching There are a few things that can affect the reading.
"auto" or desired humidity level.
The climate (example - if in a very cold climate, the furnace will
run frequently, letting dry air into the room).
The room may be too large and may be open to other spaces.
Try warm humidification, sometimes this increases the
humidity faster.
Also, unplugging it for a period of 5-8 minutes. Sometimes it is
possible to overload the unit when first getting the product and
trying out all the buttons.
E-13