Barco ImagePRO–4K Safety Manual page 6

Safety guidelines
• During maintenance operations, always switch off the unit and unplug the power cords before removing
the cover, unless otherwise stated.
• Always wear a wrist band which is connected to the ground while handling the ESD sensitive parts.
• Wear insulating gloves during the execution of the installation and maintenance actions to avoid short-
circuit.
• Be careful never to drop anything into the ImagePRO–4K video processor assembly during the procedure.
The fall of a tool or a spare part in the unit could have catastrophic consequences when you will restart the
system.
• Be careful to always follow strict procedures during maintenance operations (spare parts replacement).
• This product is intended to operate from a power source that will not apply more than 230 volts rms
between the supply conductors or between both supply conductor and ground. A protective ground
connection by way of grounding conductor in the power cord is essential for safe operation.
• This product is grounded through the grounding conductor of the power cord. To avoid electrical shock,
plug the power cord into a properly wired receptacle before connecting to the product input or output
terminals. A protective-ground connection by way of the grounding conductor in the power cord is essential
for safe operation.
• Use only the power cord and connector specified for your product. Use only a power cord that is in good
condition. Refer cord and connector changes to qualified service personnel.
• To avoid fire hazard, use only the fuse having identical type, voltage rating, and current rating
characteristics. Refer fuse replacement to qualified service personnel.
• Replace spare parts only with the same or equivalent type recommended by the manufacturer.
• Save the original shipping carton and packing material. They will come in handy if you ever have to ship
your equipment. For maximum protection, repack your set as it was originally packed at the factory.
• Rated maximum ambient operating temperature, t
• To avoid explosion, do not operate this product in an explosive atmosphere.
1.3 Environmental condition check
Environment condition check
The unit must always be mounted in a manner which ensures both air inlets and outlets are free. For
installations in environments where the device is subject to excessive dust, it is highly advisable to take
measures to prevent the dust from reaching the unit. If this is not a feasible , then the unit should be relocated
to a different dust-free location.
It is the customer's responsibility to ensure at all times that the device is protected from the harmful effects of
hostile airborne particles in the environment of the device. The manufacturer reserves the right to refuse repair
if a device has been subject to negligence, abandon or improper use.
Environment conditions
Table below summarizes the physical environment in which the ImagePRO–4K video processor may be safely
operated or stored.
Environment
Ambient Temperature
Air cleanliness
Humidity
Altitude
Environment
Do not install the device in a site near heat sources such as radiators or air ducts, or in a place subject to
direct sunlight, excessive dust or humidity. Be aware that room heat rises to the ceiling; check that
temperature near the installation site is not excessive.
6 R5906169-00 ImagePRO–4K
a
Operating
0°C (32°F) to 40°C (104°F)
Clean office environment (equivalent with
cleanroom standard ISO 14644-1 ISO Class
9)
5% to 85% RH Non-condensed
-60 (-197Ft) to 3000m (9843Ft)
= 40°C (104°F).
Non-Operating
-10°C (14°F) to 60°C (140°F)
n.a.
0% to 95% RH Non-Condensed
-60 (-197Ft) to 10000m (32810Ft)