Indoor Unit Installation; Installation Location - MrCool DIY E Star Series Owners & Installation Manual

Indoor Unit Installation

Installation Instructions
– Indoor Unit
PRIOR TO INSTALLATION:
Before installing the indoor unit, refer to the
label on the product box to make sure that
the model number of the indoor unit matches
the model number of the outdoor unit.
Step 1: Select installation location
choose an appropriate location. The following
location for the unit.
P
following standards:
Good air circulation
Noise from the unit will not disturb
other people
Strong enough to support the weight of
the unit
Page 15
Installation Summary - Indoor Unit
mrcool.com
DO NOT install unit in the following locations:
Near any source of heat, steam, or
combustible gas
or clothing
Near any obstacle that might block air
circulation
Near a doorway or where outside air may blow
directly on indoor unit
In a location subject to direct sunlight
NOTE ABOUT WALL HOLE:
While choosing a location, be aware that
you should leave ample room for a wall
hole (see
piping step) for the signal cable and
refrigerant piping that connect the indoor
and outdoor units. The default position
for all piping is the right side of the indoor
unit (while facing the unit). After piping
and signal wiring are installed, use provid-
ed neoprene to pack the space making it
airtight.
4