Table of Contents
Advertisement
ENGLISH
ENGLISH
Symbols on the charger
Read all of this manual carefully
before using the appliance.
#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
$
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Read all of this manual carefully before
using the appliance.
Features
This tool includes some or all of the following features.
1. On/off switch (press and hold)
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
Fig. A
6. Wet/Dry foam insert
7. W
Fig. B
8. Squeegee
9. Brush tool
10. Crevice tool
Installation
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
u
electrical outlet for charging the vac while it is on the wall
bracket).
6
6
(Original instructions)
Fix the mounting bracket to the wall using appropriate
u
screws and plugs for the type of wall and weight of the
appliance.
Hang the appliance on the wall by placing the opening
u
on the base of the vac over the hooks in the wall mount
charging bracket.
Assembly
These models may be supplied with some of the following
accessories:
A squeege tool (8) for wet use on hard surfaces.
u
A brush tool (9) for furniture and stairs.
u
10
u
Fitting (Fig. D)
Insert the appropriate accessory into the front of the appli-
u
ance. Make sure that the accessory is pushed fully in.
Use
u
10 hours.
Place the appliance on the charging bracket whenever it is
u
not in use.
Warning! Before charging, be sure to empty all liquid contents
and dry thoroughly, to avoid damage to your appliance.
Charging the battery (Fig. C)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch (1) pressed.
Place the appliance on the charging bracket (5).
u
Plug in the charger. Switch on at the mains.
u
Leave the appliance to charge for at least 21 hours.
u
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
To switch the appliance on, press and hold the on/off
u
switch (1).
To switch the appliance off, release on/off switch (1).
u
Wet and dry pick up
For everyday spills of dry material, use your appliance
u
without the squeegee accessory.
Advertisement
Table of Contents
