Hoover H-GO 300 User Manual page 7

7
Setting up the Cleaning Schedule
Press the schedule button.
Press the Left/Right buttons to select a day.
Press the Up/Down buttons to select or deselect that day, several days can be selected.
When all required days are selected, press the Play/Pause button to set.
The hours will then start flashing. Set the time you want to start the scheduled cleaning. Press the Up/
Down buttons to set the hours.
Press the Play/Pause button to set the hours.
The minutes will then start flashing.
Press the Up/Down buttons to set the minutes.
Press the Play/Pause button to set the minutes.
An audible signal is given from the robot signifying that the schedule has been set.
If the audible signal is not given, press the 'AUTO'
button on the remote control.
The LED of the control lamp flashes. At the set time, the cleaning process starts. To deactivate the
start time, press the Schedule button
the remote control turns off.
Setting Power Level
Press POWER LEVEL button
between Normal Power
Setting Cleaning Mode
AUTO : Press the on/ standby button on the device or the start/ pause button on the remote control
to start the cleaning process.
Robot will automatically choose the best cleaning mode to clean you room.
PARALLEL: Press MODE button on the remote control for the robot to start cleaning under this
mode .
Fig. 12
SPOT: Press MODE button on the remote control. It cleans a intensively confined area following a
circular path .
EDGE: Press MODE button on the remote control, It will automatically start cleaning along walls,
around furniture etc
MANUAL: The Robot can be controlled using the arrows on the remote control.
RETURN TO BASE: Press the button
base. This mode can be activated during any cleaning cycle and the robot will automatically return to
the charging base.
When a cleaning cycle has been completed or the Robot's battery is low, the robot will also return to
the charging base automatically.
WARNING: If there are obstacles in the room being cleaned, the robot might not be able to reach the
Fig. 13
charging base. In this case, take the robot manually.
MAINTAINING YOUR ROBOT CLEANER
EMPTYING THE DUST CONTAINER
After vacuuming, remove the dust container.
1. Press the release button and pull it out. [Fig. 13]
2. Hold the dust container over a dust bin. [Fig. 14]
3. Use the cleaning brush when necessary to remove any excess dust from the internal surface of the
dust container or fiter surface.
4. Refit the dust container to the Robot.
CLEANING THE FILTERS
Fig. 14
The robot is fitted with a pre-motor filter. To maintain optimum cleaning performance, regularly clean
the filter cover, the pre-motor filter and the sponge filter. They should be cleaned every 5 dust container
empties and should not be washed.
1. Turn the robot off and remove from the charging station.
2. Press the dust container release button and remove the dust container from the Robot. [Fig. 13]
4. Remove all filter components and clean them separately. The assembly is done in reverse
Fig. 15
order. [Fig. 16]
Make sure, that the filter insert is correctly assembled. To ensure this, press the shorter side wall into
the fitting first, before pushing in the filter on the other sides by pressing down on the edges.
IMPORTANT: Regularly check and maintain the filters by following the filter maintenance instructions.
This will maintain your Robot's performance.
Fig. 16
[Fig. 12]
button on the robot, then press the schedule
for approx. 3 seconds. The Schedule symbol in the display of
on the remote control to select the desired power level. Choose
and Turbo Power .
.
on the remote control to send the robot to the charging
* Certain Models Only ** May vary according to model
GB