Table of Contents
Advertisement
Be sure to install the device at a height that
ensures that the alignment between the devices
is visible and there are no obstructions in the
middle.
Note: The DAP-3712 is designed to receive PoE
power only from an 802.3at compliant source.
Connecting the DAP-3712 to a PoE device that
is not approved by D-Link can damage the
equipment.
Mounting on a Pole
1.
Hold the DAP-3712 against the pole in the
desired position.
Figure 9: Mounting the Device
2.
Thread the metal mounting tie through
the hole on the base of the DAP-3712 and
and wrap it around the pole. Fasten the
tie to secure the device against the pole.
TECHNICAL SUPPORT
4
Figure 10: Completed Installation
RF Frequency Requirements
This device is for outdoor use. High power
radars are allocated as primary users of the
5150 ~ 5250 MHz, 5725 ~ 5825 MHz bands.
These radar stations can cause interference
with and/or damage the PoE injector included
with this device.
dlink.com/support
Quick Installation Guide
Advertisement
Table of Contents
