Download Print this page

Advertisement

DWL-AG700AP Install Guide
User's Guide
Version 3.00
ANT24-Series
ANT70-Series
D-Link Antenna Kits

Advertisement

   Related Manuals for D-Link ANT24-1800

   Summary of Contents for D-Link ANT24-1800

  • Page 1

    DWL-AG700AP Install Guide User’s Guide Version 3.00 ANT24-Series ANT70-Series D-Link Antenna Kits...

  • Page 2

    System Requirements ANT4-0700 Install Guide Installation Note: /antenna With Surge protector adaptor on an outdoor serial is attached to the lightning protestion system (ground) of the building. All devices downstream are then protected by the ground from lightning strikes.It can (If needed) protect your sensitive WLAN equipments from high voltage surges caused by dischargeand transients...

  • Page 3

    System Requirements Installation Surge protector Installation guide for outdoor antenna-kit Step 1 loosen the screw from the surge protector. Option (1) Option (2) Step 2 get a normal conductive copper wire with 2 sides stripped long enough to be conductive, these wires can lead high voltage surges into the grounding.

  • Page 4

    Outdoor Installations To fully benefit from D-Link’s extensive range of quality outdoor antennas, please note that they should be installed by a professional and must comply with the Europe Union CE wireless radio frequency output power. Cable length will affect the antenna gain dramatically.

  • Page 5

    System Requirements ANT24-Series...

  • Page 6

    System Requirements ANT4-0700 Install Guide ANT24-Series Electrical specification 58°~75° 110g without joint Environmental & Mechanical Characteristics Temperature -10°C to 55°C Humidity 100% @ 25 C Lightning protection DC ground Radome color white Radome material Weight 100gw Dimensions 132 x 42 mm...

  • Page 7

    System Requirements ANT24-Series Omni-Directional Antenna Version 1 Electrical specification for 2.4 GHz SAA04-050170 Electrical Specification Frequency range 2400 MHz - 2500 MHz Ø19×330mm Gain 5.0 dBi Environmental & Mechanical Characteristics VSWR 2.0 : 1 Max. Polarization Linear, vertical Survival wind speed 180 km/hr Temperature -40 C to +80 C...

  • Page 8

    2400~2500MHz Impedance 50Ω Normal ANT24-0700 / ANT24-0700C VSWR 1.92 Max Return Loss -10 dB Maximum Far-field amplitude of D-link-7dBi-H1-1020.nsi Far-field amplitude of D-link-7dB Antenna Structure Helis antenna Peak Gain ( w/o cable loss) 5dBi Admitted Power Cable loss( 1.5m) 2.1dB@2.45GHz E-Plane 36 deg.

  • Page 9

    System Requirements ANT24-Series Electrical specification Frequency Range 2400~2500MHz Impedance 50Ω Normal VSWR 1.92 Max Peak Gain 5dBi Admitted Power E-Plane 36 deg. H-Plane 360 deg. Physical Properties Connector Reverse SMA plug Antenna Material ABS, ABS+PC Operating Temp -20°C ~ +65°C Storage Temp -30°C ~ +75°C Color...

  • Page 10

    System Requirements ANT4-0700 Install Guide ANT24-Series ANT24-Series D-Link ANT24-0502 Indoor Omni Directional Antenna Electrical Specification Frequency range 2400 MHz - 2500 MHz Gain 5.0dBi VSWR 2.0 : 1 Max Polarization Linear, vertical HPBW/horizontal 360° HPBW/vertical 40° Downtilt 0° Power handling...

  • Page 11

    System Requirements ANT24-Series Electrical specification 5.0dBi Typical 2.0:1 Max. 360° 30 degree nominal 197 mm(length) 29.5gw 30° Far-field amplitude of C147-510017-A-V.nsi Far-field amplitude of C147-510017-A-V.nsi 2.4GHz 2.45GHz 2.5GHz 2.4GHz 2.45GHz 2.5GHz Far-field amplitude of C147-510017-A-H.nsi Far-field amplitude of C147-510017-A-H.nsi 2.4GHz 2.45GHz 2.5GHz 2.4GHz...

  • Page 12

    System Requirements ANT24-0700 Install Guide ANT24-Series Electrical specification Frequency Range 2400~2500MHz Impedance 50Ω Normal VSWR 1.92 Max Return Loss -10 dB Maximum Antenna Structure Pateh antenna Peak Gain ( w/o cable loss) 6.0 dBi @ 2.45GHz ( typical) Admitted Power Cable loss( 1.5m) 2.1dB@2.45GHz E-Plane...

  • Page 13: Package Contents

    Operating Temp -20°C ~ +65°C Storage Temp -30°C ~ +75°C Color Antenna: Metallic gray and silver Base: Metallic gray Package Contents -D-Link ANT24-0700 2.4GHz Omni-Directional Indoor Antenna -SMA to TNC Adapter -Magnetic Base with 1.5m Extension Cable -Mounting Kit -Installation Guide...

  • Page 14

    System Requirements ANT24-0700 Install Guide ANT24-Series Electrical specification Frequency Range 2400~2500MHz Impedance 50Ω Normal VSWR 1.92 Max Return Loss 10 dB Maximum Antenna Structure Helis antenna Peak Gain ( w/o cable loss) 7dBi Admitted Power Cable loss( 1.5m) 2.1dB@2.45GHz E-Plane 24 deg.

  • Page 15

    Omni-Directional Antenna for 2.4 GHz System Requirements ANT24-Series ANT24-0800A2 Electrical specification Electrical Specification Frequency range 2400 MHz - 2500 MHz Gain 8.0 dBi VSWR 2.0 : 1 Max. Polarization Linear, vertical HPBW / horizontal Ø19×520mm 340g without joint HPBW / vertical Environmental &...

  • Page 16

    System Requirements ANT24-0700 Install Guide ANT24-Series Electrical specification Frequency 2400~2500MHz Gain 8.5 dBi VSWR 1.5 : 1 Max Polarization Linear, vertical HPBW / horizontal HPBW / vertical Front to back ratio 15 dB Power handling 50 W (cm) Impedance 50 Ohms Connector N - female Environmental &...

  • Page 17

    System Requirements ANT24-Series Electrical specification Frequency range 2400 MHz - 2500 MHz Gain 12 dBi VSWR 1.5 : 1 Max Polarization Linear, vertical HPBW / horizontal HPBW / vertical Front to back ratio 15 dB Downtilt Power handling 20 W(cm) Impedance 50 Ohms Connector...

  • Page 18

    System Requirements ANT24-0700 Install Guide ANT24-Series Electrical specification Frequency range 2400 MHz - 2500 MHz Gain 12 dBi VSWR 1.5 : 1 Max Polarization Linear, vertical HPBW / horizontal HPBW / vertical Front to back ratio 15 dB Downtilt Power handling 10 W (cm) Impedance 50 Ohms...

  • Page 19

    System Requirements ANT24-Series...

  • Page 20

    System Requirements ANT24-0700 Install Guide ANT24-Series Electrical specification Frequency range 2400 MHz - 2500 MHz Gain 14 dBi VSWR 1.5 : 1 Max Polarization Linear, vertical HPBW / horizontal HPBW / vertical Front to back ratio 15 dB Downtilt Power handling 10 W (cm) Impedance 50 Ohms...

  • Page 21

    System Requirements ANT24-Series Electrical specification Frequency range 2400 MHz - 2500 MHz Gain 18 dBi VSWR 1.5 : 1 Max Polarization Linear, vertical HPBW / horizontal HPBW / vertical Front to back ratio 26 dB Downtilt Power handling 50 W (cm) Impedance 50 Ohms Connector...

  • Page 22

    System Requirements ANT24-0700 Install Guide ANT24-Series...

  • Page 23

    6.Anchor Picture (2) vertically to the horizontal surface, not recommended to mount it perpendicular to the wall. Package Contents 2.4 GHz: 5 GHz: -D-Link ANT70-0800 Antenna -Extension Cable(50cm) -Surge Protector -Mounting Kit Picture (3) -Water-proof tape Wall -Quick Installation Guide...

  • Page 24

    6.Anchor Picture (2) vertically to the horizontal surface, not 2.4 GHz: 5 GHz: recommended to mount it perpendicular to the wall. Package Contents -D-Link ANT70-0801 Antenna -Extension Cable(50cm) -Surge Protector -Mounting Kit -Water-proof tape Picture (3) -Quick Installation Guide Wall...

  • Page 25

    Radome material ABS, UV resistant Weight 150 g 5 GHz: Dimensions 114 x124 x 40 mm 2.4 GHz: 5 GHz: 2.4 GHz: 5 GHz: Package Contents -D-Link ANT70-1000 Antenna -Extension Cable(50cm) -Surge Protector -Mounting Kit -Water-proof tape -Quick Installation Guide...

  • Page 26

    5 GHz: Radome material ABS, UV resistant Weight 400 g Dimensions 200 x218 x 50 mm 2.4 GHz: 5 GHz: 2.4 GHz: 5 GHz: Package Contents -D-Link ANT70-1800 Antenna -Extension Cable(50cm) -Surge Protector -Mounting Kit -Water-proof tape -Quick Installation Guide...

  • Page 27

    System Requirements Fresnel Zone Line-of-Sight (LOS) Visual and RF Line-of-Sight ( LOS ) between the sending and receiving antennas is essential in achieving long range in wireless communication systems. There are two types of LOS that are generally used to describe an environment: Visual LOS is the ability to see from one site to the other.

  • Page 28

    System Requirements ANT24-0700 Install Guide Fresnel Zone How far above the ground and other obstacles the antennas need to be is determined by the radius of the Fresnel zone. The radius of the Fresnal Zone depends upon the frequency and distance between the two radios. The following table provides approximate Fresnel zone radius: In order to have LOS clearance, the combined antenna height should be equal to or at least 70% of the radius of the Fresnel zone.

  • Page 29

    System Requirements ANT24-Series...

  • Page 30

    System Requirements ANT24-0700 Install Guide...

  • Page 31

    System Requirements...

  • Page 32

    System Requirements ANT24-0700 Install Guide...

  • Page 33

    System Requirements...

  • Page 34

    Ver. 3.00 DFWWANT00C0030...

Comments to this Manuals

Symbols: 0
Latest comments: