Table of Contents
Advertisement
Hardware Installation
Assembling the Access Point
1.
Assemble the dish of the DAP-3712 by
sliding the two halves together until they
lock in place.
Figure 3: Assembling the Dish
2.
Connect the antenna and base through
the hole in the center of the dish.
Figure 4: Attaching the Antenna
2
3.
Thread a standard RJ-45 Ethernet cable
through the cover for the PoE port on
the underside of the DAP-3712. Insert the
cable into the PoE port, then attach the
cover to the device.
Figure 5: Connecting the Ethernet Cable
4.
Connect the adjustment kit to the base of
the DAP-3712 by pressing it in until it clicks
and locks in place. Use the adjustment
kit to position the antenna at the desired
angle
Figure 6: Attaching the Adjustment Kit
Powering the Access Point
To power the DAP-3712, use a standard Ethernet
cable to connect the PoE port on the DAP-3712
to a PoE power source device such as a PoE
switch or the included PoE injector.
Quick Installation Guide
Advertisement
Table of Contents
