Advertisement
MOUNTING
04
SP500X ON HAND
The SP500X is equipped with a pre-installed nger strap. To correctly mount
the SP500X on your hand, you will need to install a wrist strap.
Note: There are two wrist strap sizes available for purchase seperately.
Finger Strap Clip
Tips:
Be careful to not over-tighten the straps.
Remove all jewelry from your wrist and hand.
Always maintain a relaxed wrist posture and low impact when printing.
Wrist Strap Clip
01. Install the wrist
strap by snapping the
triangle-shaped clip* onto
the clip holder as shown,
with the clip's interior angle
pointing upwards.
*preinstalled on wrist strap
02. Secure the SP500X to the
back of the hand using the
wrist strap and nger strap.
Adjust the straps to ensure a
secure and comfortable t.
Two or three ngers may be
used based on what is most
comfortable to user.
Advertisement
