Advertisement
USING KEYPAD AND
03
LED FEEDBACK
The LCD and keypad allow for
navigation through the SP500X
menus to retrieve data and alter
settings.
To reboot, press and hold the
green power button for ten (10)
seconds to put the SP500X into
sleep mode.
After releasing the button, press
the same button again and the
SP500X will reboot.
There are two LEDs located at the back of the SP500X, on either side.
The LED colors & behavior communicate various feedback.
Initial
Power Up,
Ready
to Print
L+R - Solid Green
Firmware
Updating
R - Solid Red
SP500X
Navigate Down
Previous
Power / Enter
Firmware
Downloading
L+R - Blinking Green
System
Error*
L+R - Blinking Red
*low ink, failed print,
door open, low battery
Advertisement
