Advertisement
Connect the Module Beneath the Table
The FT2A-PWR-US-1, FT2A-PWR-US-2, and FT2A-PWR-US-3 provide two NEMA ac power
receptacles beneath the table (the FT2A-PWR-US-1-BASIC does not). Use these receptacles to
provide power to an electrical FT2 FlipTop assembly and to devices installed below the surface
within the FT2 FlipTop assembly system.
Make Connections Beneath the Table (FT2A-PWR-US-2 Module Shown)
FT2-700-ELEC
power supply
FT2-700-ELEC
DM-TX-201-C
FT2A-UTK-SHELF
Power receptacle (2)
(18 in., 457 mm)
FT2A-PWR-US
power cord (8 ft)
To activate the power outlet module, insert the three-prong power cord into a nearby AC wall or
floor outlet.
Compliance and Legal
Original Instructions: The U.S. English version of this document is the original instructions. All other languages are a translation
of the original instructions.
Regulatory Models: FT2A-PWR-US-1 FT2A-PWR-US-1-BASIC FT2A-PWR-US-2 FT2A-PWR-US-3
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not
cause harmful interference and (2) this device must accept any interference received, including interference that may cause
undesired operation.
CAUTION:
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the
user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
Operate the Module Above the Table
To operate the power outlet module:
1.
Tap the lid retraction button to retract the one-touch lid, which disappears into the FT2
FlipTop assembly.
2.
Connect the device needing power to one of the available outlets on the module.
3.
Confirm that the power indicator on the device shows that the device is receiving power.
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This product is Listed to applicable UL® Standards and requirements tested by Underwriters Laboratories Inc.
For Additional Information
Scan or click the QR code for detailed product information.
FT2A-PWR-US-1
FT2A-PWR-US-2
FT2A-PWR-US-3
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, please visit www.crestron.com/opensource.
Crestron, the Crestron logo, and FlipTop are either trademarks or registered trademarks of Crestron Electronics, Inc. in the
United States and/or other countries. UL and the UL logo are either trademarks or registered trademarks of Underwriters
Laboratories, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may
be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any
proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography.
©2019 Crestron Electronics, Inc.
Crestron Electronics, Inc.
15 Volvo Drive, Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7576
www.crestron.com
FT2A-PWR-US-1-BASIC
Quick Start - Doc. 8218C
(2053217)
03.19
Specifications subject to
change without notice.
Advertisement
