Gree G17-10ESHWAC-CA Owner's Manual page 13

OPERATING INSTRUCTIONS
Remote Control Operation
NOTICE:
•
•
SYMBOL DESCRIPTION
Power Button
Mode Button
Increase /
Decrease Button
Swing Button
Fan Button
Sleep Button
Timer Button
i-Feel Button
Light Button
Additional Features Available Only On Your Remote
Energy
Saver
Mode
Auto
Mode
Dry
Mode
The distance between remote and receiving window should be no more than 8 m
(26 ft.), and there should be no obstacles between them.
When not using the remote control for extended periods of time, please take out
the batteries.
Turns air conditioner On and Off. Turning on the unit with remote controller,
the unit will operate in ENERGY SAVER mode.
Press the button to select a mode from the following options:
AUTO - COOL - ENERGY SAVER - DRY - FAN
Press + or - button to increase or decrease set temperature by 1º. Hold (+) or (-)
button for 2 seconds to quickly adjust the temperature on the remote control.
Press to turn ON or OFF air flow oscillate
This button is used for setting Fan Speed in the sequence that goes from
AUTO — Speed 1 — Speed 2— Speed 3
Press this button to operate in SLEEP mode. Press it again to cancel. This function is
available in COOL, DRY and ENERGY SAVER mode to maintain the most comfortable
temperature.
Press this button to initiate AUTO-ON/AUTO-OFF timer
Press this button twice to cancel auto-timer
i-Feel function will activate after pressing this button. This will work with the rooms
ambient temperature, sending the remote programmed thermostat temperature to the
unit every 10 minutes If power is lost this function will need to be reset.
Press this button to turn on the display light. Press this button again to turn off
the display light
Air conditioner operates under ES mode. ES indicator will be on. Press Fan button on the remote
to adjust the fan speed or ES mode.
Will monitor room's ambient temperature, humidity and automatically adjust to comfortable room
temperature.
Unit runs in low fan speed for dehumidification. Dry Mode indicator will be on. Fan speed cannot
be adjusted.
FUNCTION
13