Adjusting Ski Stance; Single Wear Bar; Dual Wear Bar - Yamaha SRS10ML53 Owner's Manual

Installing (Dual)
1. Position the wear bars in the ski and
loosely secure using the existing
spacers, washers and nuts.
2. Tighten the nuts evenly to 2.0 kg-m
(15 ft-lb).

Adjusting Ski Stance


NOTE: Local laws and/or regula-
tions as to maximum width of the
ski stance on these snowmobiles
may be applicable. Always comply
with the maximum width laws and/
or regulations when adjusting ski
stance.

Single Wear Bar

1. Place the front of the snowmobile on
a support stand.
2. Remove the cotter pin; then remove
the slotted nut and cap screw secur-
ing the ski assembly to the spindle.
Remove the ski. Account for the ski
damper, inserts, spacer and washers.
Spindle Axle
Spacer
Cotter Pin
Nut
Washer
SNO-681A
3. To increase ski stance, place ski
stance spacer to the outside of the
spindle and adjust the damper.
4. To decrease ski stance, place ski
stance spacer to the inside of the
spindle and adjust the damper.
5. Apply an all-temperature grease to the
non-threaded portion of the cap
screw; then slide the cap screw
through the ski accounting for the rub-
ber damper, inserts, and washers.

NOTE: Install the cap screw so
SNO-813 the nut will be located to the inside
of the ski.
6. Apply Yamabond Red Threadlocker
to the threads of the cap screw; then
tighten the nut to 6.2 kg-m (45 ft-lb).
7. Place the cotter pin into the ski cap
screw and spread the pin.
8. Repeat procedure for the other ski.

Dual Wear Bar

1. Place the front of the snowmobile on
a support stand.
2. Remove the cotter pin; then remove
the slotted nut and cap screw secur-
ing the ski assembly to the spindle.
Remove the ski. Account for the
rubber damper, inserts, and washers.
3. To increase ski stance, place ski
stance spacer to the outside of the
spindle and adjust the damper.
4. To decrease ski stance, place ski
stance spacer to the inside of the
spindle and adjust the damper.
Ski Damper
Insert
Washer
Cap
Screw
0750-103
42