Error Messages - Panasonic KX-TGD324AL Operating Instructions Manual

Useful Information
Cyrillic character table (
z
1 2

Error messages

Display message
Base no power
or
No link.
Reconnect
AC adaptor.
or
No link.
Check
Phone Line
Error
Memory Full
Use
rechargeable
battery.
You must first
subscribe
to Caller ID.
46
)
3 4 5
Cause/solution
R Confirm the base unit's AC adaptor is connected to the unit
and the power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 33).
R When "No link." is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
R Recording was too short. Try again.
R The phonebook memory is full. Erase unwanted entries
(page 20).
R The call block list memory is full. Erase unwanted entries
(page 30).
R The maximum number of base units (4) is already registered
to the handset. Cancel unused base unit registrations from
the handset (page 34).
R A wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
6 7 8
y
9