Heat Sink Fan - HP Spectre x360 Convertible 13-w000 Maintenance And Service Manual

Heat sink fan

Description
Heat sink fan (includes cable)
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side
of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature
sensor and is designed to turn on automatically when high temperature conditions exist. These conditions are
affected by high external temperatures, system power consumption, power management/battery
conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced
through the ventilation grill located on the left side of the computer.
Before removing the fan, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the heat sink fan:
1. Disconnect the fan cable (1) from the system board.
2. Remove the two Phillips PM2.0×3.0 screws (2) that secure the fan to the computer.
3. Remove the fan (3).
Reverse this procedure to install the heat sink fan.
30 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page 24).
Spare part number
907333-001
Battery on page 26).