Connecting Scsi Devices - Adaptec 2120S Installation Manual

C
ONNECTING
You can connect up to 15 SCSI devices to the Adaptec SCSI Card
19160. Before connecting devices, be sure to review Setting Up
SCSI Devices on page 5. For additional details on connecting
devices, refer to the Adaptec SCSI Card 19160 User's Reference.
Connecting Internal LVD (Ultra160 and Ultra2) SCSI
Devices
Connect internal LVD SCSI devices to the internal LVD/SE
connector on the Adaptec SCSI Card 19160. To do this, use a
68-pin internal LVD cable like the one shown in Step 1 below.
Follow these steps to connect the devices:
N
OTE
separate from your SE (Ultra SCSI) devices. This allows LVD
SCSI devices to transfer data at their maximum speed. (See
Bus Segments on the Adaptec SCSI Card 19160 on page 2.)
Locate a 68-pin internal LVD SCSI cable, which should have
S 1
TEP
twisted wires as shown below to support LVD devices.
Terminated End
SCSI D
EVICES
We recommend that you keep your LVD SCSI devices
Adaptec SCSI Card 19160
Nonterminated End
7