Table of Contents
Advertisement
STEP 3
Remove the attachment pipe from the housing base by
loosening 4 screws.
* Special screw (mounting screw): Use a hexagon
wrench for the hexagon screw (M6).
STEP 4
(1) Fix the bracket to the installation surface using
appropriate bolts, nuts or the like (not supplied).
(2) Fix the attachment pipe to the bracket.
STEP 5
Thread cables through the bracket. Connect the cables
to the camera ( ☞ page 20).
Warning:
• Seal the cables with plastic or rubber tape to
prevent it from being exposed.
Housing Base
x4 Screws
Attachment Pipe
Cables
STEP 6
Fix the housing base to the attachment pipe.
• Fasten 4 screws (the screws that were removed in
step 3) making sure that "REAR" engraved on the
housing base faces the wall.
(Recommended tightening torque: 2.45 N·m {25 kgf·cm})
• Fill the gap between the bracket and attachment
pipe with waterproof material such as silicon clay.
See instructions of the bracket for details.
Important:
• Carefully apply the sealing so that water or
moisture cannot get inside. If water gets
inside the camera it could cause a shock or
fire. Also, if moisture gets inside the camera it
could cause the dome to become foggy.
REAR
STEP 7
(1) Check that the projection of the leaf spring on the
top of the camera is at the "START" position. If the
projection is not at the "START" position, turn the
plate clockwise to match it to the "START" position.
Leaf Spring
Plate
Waterproof Material
x4 Screws
Housing Base
REAR
Bending
17
Advertisement
Table of Contents
