Table of Contents
Advertisement
MAINTENANCE
4.9
Mounting the pumphead
1.
Attache a hoist to the pumphead.
2.
Move the pumphead horizontally towards the
support set. Make sure the coupling halves (B)
and the spider mesh correctly.
3.
Place the fasteners (A). Do not tighten them.
4.
Use two alignment jigs (D) to check the
alignment of the coupling halves (C) in the
horizontal and vertical plane. Looking from
above and from the side, both coupling halves
(C) must touch the edge of both jigs.
If necessary move the drive (E) over the plate
(B) to accomplish this.
Axial, radial and angular displacement of the
coupling halves must be minimised.
5.
To fix the drive to the plate tighten the fasteners
(A) with the correct torque. See section 6.3.
22
A
A
B
C
D
C
E
A
B
Advertisement
Table of Contents
