Table of Contents
Advertisement
INSTALLATION
9.
Drive a pin (A) into each drilled hole to fix the
horizontal plate in the support set side plates.
10.
Use two alignment jigs (D) to check the
alignment of the coupling halves in the
horizontal plane. Looking from above both
coupling halves (C) must touch the edge of both
jigs.
If necessary move the drive (E) over the plate
(B) to accomplish this.
Axial, radial and angular displacement of the
coupling halves must be minimised.
11.
Mark the holes (A) for fixing the drive on the
plate of the support set using a punch and a
hammer, or a felt-tip pen.
12.
Remove the alignment jigs and use a hoist to
remove the drive.
13.
Drill holes, with the correct diameter, in the
horizontal plate (B) at the marked places. See
section 6.3.
14.
Remount the drive and slide it toward the
pumphead so that the coupling halves mesh.
15.
Fix the drive to the horizontal plate with
fasteners (C) (washers, bolts and nuts). Do not
tighten the fasteners yet.
16.
Repeat step 10. (alignment in a horizontal
plane)
Tighten the fasteners (C) and the screws of the
coupling halves with the correct torque. See
section 6.3.
17.
Place the coupling guard (A).
Tighten the fasteners (B) with the correct
torque. See section 6.3.
12
A
C D C E
A
C
B
A
B
Advertisement
Table of Contents
