Table of Contents
Advertisement
Step 1 Unpack the ARMC/2 Card (and check jumper settings),
Check the following jumpers:
Jumper
JP4
JP5
JP6
JP7
JP8
JP11
JP12
JP13
JP14
Note:
The ARMC/2 cards have these two jumpers, JP13 and JP14.
JP4 and JP5 Chassis/Motherboard Power Switch
Verify that there is no jumper on JP4 and JP5. These two headers are to be used with a
cable, not a jumper.
JP6 ARMC/2 Reset Button
You can temporarily short this jumper to reset your ARMC/2 card. For normal operations,
verify that there is no jumper on JP6.
Pin
1
2
JP7 and JP8 Chassis/Motherboard Reset Switch
Verify that there is no jumper on JP7 and JP8. These two headers are to be used with a
cable, not a jumper.
JP11 Flash Write Enable/Disable
You can write-protect your ARMC/2 card's firmware so that it cannot be flashed. By
default, pins one and two are shorted so that you can flash the firmware.
Pin
1
2
3
Pin
1-2
2-3
6
ARMC/2 User's Guide
Setting
Confirm that pins one and two are open.
Confirm that pins one and two are open.
Confirm that pins one and two are open.
Confirm that pins one and two are open.
Confirm that pins one and two are open.
Confirm that pins one and two are shorted.
Confirm that pins one, two and three are open.
If your hosts system's motherboard has support for I2C on the PCI slots,
place a short pins one and two. If not, confirm that pins one and two are
open.
If your hosts system's motherboard has support for I2C on the PCI slots,
place a short pins one and two. If not, confirm that pins one and two are
open.
Description
Ground
Reset #
Description
VCC3
Write-Protect Enabled
Ground
Description
Flash Write Enable
Flash Write Disable
Continued
Cont'd
Advertisement
Table of Contents
