Cannot Power On the Host System Remotely
Problem
Cannot remotely power on, power off, or power cycle the host system.
Symptom
When connected to the ARMC/2 remotely (using the GUI), power on, power off, and
power cycle does not work properly.
Solution
The user should make sure that the feature cable is connected properly from the ARMC2
card and the host system's main board and chassis. The wall AC adapter must be
connected to the ARMC/2 card in order for power control options to operate properly.
Complete Flash
Problem
Deciding whether to do a Complete flash instead of selecting individual modules during a
firmware upgrade.
Symptom
After flashing the new firmware to the ARMC/2, there are unexpected errors.
Solution
Whenever there is a change in Config section of the new firmware image, the user must
perform a Complete flash. Otherwise the default selected modules are sufficient for
flashing.
Appendix D : Troubleshooting 135