Asus ROG STRIX B360-H GAMING Manual page 28

10. ATX power connectors (24-pin EATXPWR; 8-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
STRIX B360-H GAMING
ROG STRIX B360-H GAMING ATX power connectors
•
•
•
•
1-16
A
B
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a
minimum power of 350 W.
DO NOT forget to connect the 8-pin EATX12V power plug. Otherwise, the system will
not boot.
We recommend that you use a PSU with a higher power output when configuring a
system with more power-consuming devices. The system may become unstable or
may not boot up if the power is inadequate.
If you want to use two high-end PCI Express x16 cards, use a PSU with 1000W power
or above to ensure the system stability.
A B
EATX12V EATXPWR
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
PIN 1
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
PIN 1
Chapter 1: Product Introduction
GND
+5 Volts
+5 Volts
+5 Volts
-5 Volts
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts