Table of Contents
Advertisement
3.4
To change Normal mode (closed loop) setpoint or Manual mode (open loop) output percentage:
3.5
To view and change parameter values:
To change the value of this parameter for a different zone, press
of the zone you want is displayed.
3.6
CONFIGURATION
There are five distinct configuration menus, namely:
MENUS
Input Configuration
Boost Configuration
Control Configuration
Display Configuration
Alarm Configuration
NOTE: A password-
with parameters in each menu that need to be set for your process. When a parameter is
protected Factory
accessed, the display of its name alternates with the display of its current value. At the factory, all
menu is also available.
zones' settings are identical. Information about each parameter and how to set it is described in
The password is
Section 5.
available only from
the Athena technical
Additionally, there is a Supervisor Configuration, and a Factory Configuration menu which have
support team.
limited accessability.
Percentage configured with Boost Config menu.
Idle—zone's output is off until another mode is selected using the front panel
— OR —
— OR —
is pressed to put all Idle zones in the Run state
Offline—zone's output is off and PROC (displayed as PROCESS on RMB/1) is not monitored
by the controller
CHANGING THE SETPOINT
1) Select a zone or, if all zones are in the same mode (Normal or Manual), select all zones as
described in section 3.2.
2) Press
or
to change the setpoint or output percent. A few seconds after you stop
pressing an arrow button, the main display, PROC (displayed as PROCESS on RMB/1) and
SETP (displayed as SETPOINT on RMB/1), will return.
CHANGING A CONFIGURATION PARAMETER VALUE
1) Select one zone or all zones as described in section 3.2.
2
Press and hold
to enter the menu system.
3) Step through the menus by pressing
is displayed. Notice that if you selected all zones before entering the menu system (or if the
parameter, such as Display Units, applies to all zones), an asterisk
a zone number. This asterisk indicates that the change will apply to all zones.
4) Step through the menu items by pressing
alternating with its current value.
5) Change the value by pressing
hold down an arrow button for fast changes.
To change a different parameter for the selected zone, repeat steps 3 through 5 as needed.
To leave the menu system, press and hold
CONFIGURATION MENUS AND FACTORY SETTINGS
repeatedly until the name of the menu you want
until the parameter you want is displayed,
or
. When changing a numerical value, you can
for several seconds.
is displayed instead of
repeatedly until the number
11
Advertisement
Table of Contents
