Setup; Checking The Fluids And Tire Pressure; Installing The Wheel Kit; Reading The Manual And Viewing The Operator Training Material - Toro 31914 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Checking the Fluids and
Tire Pressure
No Parts Required
Procedure
•
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer
to Checking the Engine-Oil Level (page
•
Check the grease for the machine and mower
deck.
Note:
The cutting blades are set to a 51 mm (2 inch)
height of cut at initial purchase. The axle position is B,
with 2 spaces below the casters and 4 spaces below
the spindle.
2

Installing the Wheel Kit

Parts needed for this procedure:
1 Wheel Kit (sold separately)
Procedure
Refer to the Installation Instructions for the wheel kit
Description
No parts required
Wheel Kit (sold separately)
Operator's Manual
Engine owner's manual
Operator training material
Oil-drain hose
23).
Qty.
–
Check the fluids and tire pressure.
1 Install the Wheel Kit.
1
Read the Operator's Manual and watch
1
the operator training material before
1
operating the machine.
1
3
Reading the Manual and
Viewing the Operator
Training Material
Parts needed for this procedure:
1 Operator's Manual
1 Engine owner's manual
1 Operator training material
1 Oil-drain hose
Procedure
•
Read the Operator's Manual.
•
View the operator training material before
operating the machine. This is general training
material and the machine may differ from that
supplied.
•
Use the oil-drain hose when changing the engine
oil.
8
Use