Philips 8000 Series Important Information Manual page 11

Hide thumbs Also See for 8000 Series:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Signal
Description of signal
Error code 'E6' lights up on the display.
Note: When the appliance is charging on the
charging station, the E6 error code may look like
the number 93.
Error code 'E7' lights up on the display.
Note: When the appliance is charging on the
charging station, the E7 error code may look like
the designation L3
Error code 'SE' lights up on the display.
Note: When the appliance is charging on the
charging station, the SE error code may look like
the number 35.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The appliance does not
work when I push the
slider.
The appliance has a lower
suction power than usual.
Possible cause
When the battery is empty,
the following icon flashes on
the display:
You have to push the slider
forward to switch on the
appliance.
The filter and the cyclone are
dirty.
Meaning of signal
The adapter or battery may be
defective. Please contact the
Consumer Care Center or take the
appliance to an authorized Philips
service center.
The adapter may be defective.
Please contact the Consumer Care
Center or take the appliance to an
authorized Philips service center.
SE stands for service. Please take the
appliance to an authorized Philips
service center.
Solution
To charge the battery, connect the
appliance to the charging station or
attach the handheld vacuum cleaner
directly to the magnet on the charging
station (Fig. 10).
Push the slider forward to setting 1 to
switch on the appliance. Increase the
suction power further by pushing the
slider to setting 2 or select the Turbo
setting to clean very dirty patches at the
highest suction power.
Empty the dust bucket. Clean the filter
(Fig. 9) and the cyclone (Fig. 11). The filter
light lights up after several hours of use
to indicate that you have to wash the
sponge filter. Make sure that you wash
the sponge filter at least once a month if
you use the appliance regularly. Make
sure that you remove any hair and dirt
that is stuck in the cyclone.
English
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xc8349/01Xc8147/01Aqua plus 8000 series

Table of Contents