Related Manuals for Philips 8000 Series
Summary of Contents for Philips 8000 Series
- Page 1 Headphones 8000 Series TAT8505 User manual Register your product and get support at www.philips.com/support...
-
Page 2: Table Of Contents
Contents Important safety instructions Hearing Safety General information 2 Your Bluetooth True wireless earphones What's in the box Other devices Overview of your True wireless earphones 3 Get started Charge the battery Pair the headphones with your mobile phone 4 Use your headphones Connect the headphones to a Bluetooth device Control ANC (active noise... -
Page 3: Important Safety Instructions
1 Important General information safety To avoid damage or malfunction: instructions Caution Do not expose headphones and charging case to Hearing Safety excessive heat. Do not drop your headphones and charging case. Headphones and charging case shall not be exposed to dripping , splashing water. -
Page 4: Earphones
Quick start guide Congratulations on your purchase, and Other devices welcome to Philips! To fully bene t from the support that Philips o ers, A mobile phone or device (e.g. note- register your product at book, PDA, Bluetooth adapters, MP3 www.philips.com/welcome. -
Page 5: Overview Of Your True Wireless Earphones
Overview of your True wireless earphones Microphone Multi-function touch LED indicator (Earpieces) LED indicator (charging box) Bluetooth pair button USB-C charging slot... -
Page 6: Get Started
3 Get started Charge the battery Note Before you use your earpieces for the rst time, place the earpieces in the charging box Normally, a full charge takes 1.5 hours (for the and charge the battery for 3 hours for earpieces or charging box) by USB cable. -
Page 7: Mobile Phone
Make sure that the headset is fully charged and powered o . Philips TAT8505 Open the top cover from charging box, press and hold the pairing button from charging box back for approximately 3 seconds... -
Page 8: Use Your Headphones
4 Use your Control ANC (active noise earpieces cancelation) Enable ANC Connect the earpieces to Di erent ANC mode can be toggled via double tap on the right earpiece. your Bluetooth device • ANC function is auto active when put into the ear. Turn on the Bluetooth function of •... -
Page 9: Manage Your Calls And Music
Call control ANC LED indicator status Operation Task Multi- Headphones status Indicator function ANC mode is The blue LED will button toggled turn on. Pick up/ Right Double Switch caller earpiece taps during a call Hang up call Right Tap and Power on/o /Reject call hold... -
Page 10: Led Indicator Status
Charging Box Indicator Battery LED indicator on LED (USB o ) Bluetooth device It will show a battery indicator on Bluetooth device after connected to earpieces. Voice Assistant When USB is o , the LED is lit for 30s after case open or closed Task Operation... -
Page 11: Factory Reset The Headset
Transmitter power: < 10 dBm imately 3 seconds. Then, turn on Operating range: Up to 10 meters (33 the Bluetooth function of your feet) Bluetooth device, select Philips Auto power o TAT8505. USB-C port for charging Wireless charging Low battery warning: available Note ... -
Page 12: Notice
2013/56/EU which cannot be disposed of with normal household waste. We strongly advise you to take your product to an o cial collection point or a Philips service centre to have a professional remove the rechargeable battery. Inform yourself about the local separate... -
Page 13: Compliance With Emf
frequency energy and, if not installed Compliance with EMF and used in accordance with the instruction manual, may cause harmful This product complies with all applica- interference to radio communications. ble standards and regulations regarding However, there is no guarantee that exposure to electromagnetic elds. - Page 14 L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
-
Page 15: Trademarks
7 Trademarks Bluetooth The Bluetooth word mark and logos ® are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MMD Hong Kong Holding Limited is under license. Other trade- marks and trade names are those of their respective owners. -
Page 16: Frequently Asked Questions
(see Scan the QR code/press 'Download' button ‘Pair the headset with your Bluetooth or search 'Philips Headphones' in Apple device at the st time’ on page 6). App Store or Google Play to download App. - Page 17 Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its a liates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.