Section 9 − Disassembly And Reassembly; Disassembling/Reassembling 4 Kw Generator - Miller TM-268 Technical Manual

SECTION 9 − DISASSEMBLY AND REASSEMBLY

9-1. Disassembling/Reassembling 4 kW Generator

TM-4414 Page 22
2
1
Apply SAE 30W oil to
both ends of studs
Use Section 8-2 to determine if trouble is
in stator, rotor, control box, or combina-
tion of these components.
1 Rotor
2 Stator Assembly
! Use hoist and lifting strap to care-
fully
generator .
! Do not damage rotor or stator
windings during this procedure.
.
Mark electrical leads before disas-
sembling unit.
Reassemble generator parts.
Reconnect all leads. Use cable ties to
secure leads away from moving or hot
parts.
before installing.
disassemble/reassemble
.
A 95 in lb (10.7 N m)
Tools Needed:
250 654
Belt/Hydraulic-Drive Generator