Eagle 202AKR Series Operation Manual page 29

Battery 1. Check the liquid level. Please add the
distilled water if necessary.
2. Charge the battery
3. Tighten the nut on the battery cable
4. Check if the battery is over-discharged (the
battery power meter is flashing)
5. Check the liquid density of the battery,
standard density should be 1.275±0.005
(25℃).
6. Check if the battery is charged fully by 3
ways: a) using the hydrometer; b) checking
the battery power meter;
7. Clean the surface of battery
Charger 8. Observe the charging status, check if the
charger plug becomes hot.
9. Clean the surface of the charger. Do not
get any water inside the charger.
Controller 10. Check if all terminals are tightened
properly. Please do this after the power is off.
11. Clean the surface of the controller.
12. Check if the solenoid is in order, checking
its touching point.
13. Check if any water gets in. Check if it
becomes too hot.
14. Check if the carbon brush should be
replaced.
15. Check if the accelerator pedal works well
and if it can be released freely and
automatically.
Chassis and 16. Check if the brake drum and the brake
body shoe should be replaced or not.
17. Check if the hand brake functions.
(applicable for vehicle with hand brake).
18. Check if the hose and tube for the brake
liquid leaking. (applicable for vehicle with
hydraulic brake).
19. Check if the brake liquid inside the brake
liquid tank is enough. (applicable for vehicle
with hydraulic brake).
20. Check the air pressure inside the tire,
check if the tire surface is worn, check if the
nuts are tightened properly.
—29—
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y