Eagle 202AKR Series Operation Manual page 15

To control the heater, press the lower part of the switch, the heater is turned on, press
the higher part of the switch, the heater is turned off. There is no Neutral position.
Combined Switch
The left lever of the switch is used to switch on/off the lighting system including
headlight, front turn signal, rear turn signal, taillight; the right lever is to control the wiper.
Left lever
1) The top button of the lever is used to control the headlight, turn to the first position, the
position light will be on; turn to the second position; the low beam will be on.
2) Push the lever to the front to engage the right turning light when planning to turn and
drive the vehicle to the right.
3) Push the lever to the rear to engage the left turning light when planning to turn and
drive the vehicle to the left.
4) Pull the lever to the top to engage the high beam light. The lever will be back to the
middle automatically when leaving it.
5) Press down the lever to engage the high beam light.
Right lever
Turn the top button to the on Position to engage the wiper motor, push the lever to the
front to the LO and HI position to start the wiper. Pull up the lever to start the wiper
sprinkler.
NOTE: There are three speed position signals on the right lever—INT, LO and HI, but the
wiper motor only has one speed, so we didn't connect the power to the INT position and
LO and HI position in the same speed.
Electric Horn
To be controlled by foot.
Digital Meter
The digital meter includes: indicators for high/low beam, turning signal, forward/backward
and parking brake, speedometer, milemeter, amperometer, battery power meter.
—15—