Eagle 202AKR Series Operation Manual page 12

Left turn signal
High beam light
2 Operation instruction
Ignition key
——
The Ignition key is used to switch on the electrical system of the vehicle.
The ignition key has three position, insert the key to let it on the first position; turn it
clockwise to the second position to engage the 12V accessory system (including the
headlight, turn signal, taillight, brake light, horn, wiper and digital meter); turn it clockwise
further to the third position to engage the motor and to drive the vehicle.
To switch the power off, turn the key counterclockwise to first position and pull out the
key.
NOTE: only when pull out the key, the 12V accessory system will be powered off
completely.
Accelerat or pedal
——
The accelerator pedal is used to control the speed to move the vehicle. Step it
down slowly to increase the speed. The vehicle will speed up with the gradual stepping
down of the accelerator pedal, eventually reaching the full speed when the pedal is
stepped down to the bottom. The vehicle slows down with the releasing of the pedal.
When the pedal is fully released, electric brake will function, and the vehicle will stop.
Brake Pedal ------------Step down service brake pedal to decelerate the vehicle and
finally stop the vehicle if needed.
WARNING!
It is prohibited to step down both the brake pedal and the accelerator pedal all
together; otherwise this type of operation will damage the motor badly.
Reverse light
—12—
Netural position
Forward signal
Left turn signal