Xylem Sensus FlexNet CommandLink II Quick Start Manual

FlexNet CommandLink II
The CommandLink® II wireless interface provides access to a complete
suite of functional controls within a gas, water, or electric SmartPoint®
transceiver. This Bluetooth® enabled device, coupled with a handheld,
can perform activations, deactivation, meter read, on demand reads and
audits of the SmartPoint module.
Warning: Risk of hot surface. Do not hold device longer than one (1) minute when
operating in an ambient temperature above 40°C (104°F).
Step 1: Charge the CommandLink II
You must charge the CommandLink II completely before first use.
1. Plug the charging adapter into a power outlet and connect to
the Charging Port located next to the Mag Loop on top of the
Command Link II.
Note: Make sure you have rechargeable batteries installed before using a power outlet.
Units that have non-rechargeable batteries should never be plugged into a power outlet
for charging.
2. The red LED indicator illuminates, indicating the unit is charging.
3. Unplug the unit when the red LED is no longer illuminated,
indicating the CommandLink II is fully charged.
Note: To power down the CommandLink II immediately, press and hold the power
button located on the side of the CommandLink II until the PWR LED turns off.
Step 2: Turn on the Command Link II
1. Press the power button.
2. The green LED light illuminates when the CommandLink II is
successfully powered.
Step 3: Create a Bluetooth Partnership
To use the CommandLink II, you must first establish a Bluetooth
partnership with a Windows Mobile, Android or iOS equipped handheld
device (HHD) or PC.
Package Contents
FlexNet CommandLink II
Bungee Straps (2)
Charging Adapter (AC/DC)
Vehicle Charging Adapter (DC/DC)
Case
Charging Port
Mag Loop
Battery Cover
Power
LED Description
CHG (Red) Charging
LNK (Blue) Bluetooth connected
PWR (Green) Solid: power on
Flash: needs charge/poor battery
connection/defective battery
Quick Guide
AQG-10087-04
Strap Clip
LED Indicators