Table of Contents
Advertisement
EMU29471
Replacing fuse
If a fuse has blown, remove the electrical
cover, open the fuse holder and remove the
fuse with a fuse puller (if equipped). Replace
it with a spare one of the proper amperage.
EWM00630
WARNING
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
2
3
4
3
1. Electrical cover
2. Fuse holder
3. Fuse (20 A,30 A,100A)
4. Spare fuse (20 A,30 A,100A)
5. Fuse puller
1. Fuse (20 A,30 A,100A)
2. Fuse puller
EMU29522
Power trim and tilt / power tilt will not
operate
If the engine cannot be tilted up or down with
the power trim and tilt / the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit / the power tilt unit, the
engine can be tilted manually.
1.
5
3
4
1
1. Manual valve screw
ZMU01903
2.
Trouble Recovery
1
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
1
Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
2
ZMU01904
ZMU01905
71
Advertisement
Table of Contents
