Table of Contents
Advertisement
User Manual of Explosion-Proof Bullet Camera
3. Set the date of the DST period.
4. Click
Configuring RS-232
The RS-232 port can be used in two ways:
Parameters Configuration: Connect a computer to the camera through the serial port.
Device parameters can be configured by using software such as HyperTerminal. The serial
port parameters must be the same as the serial port parameters of the camera.
Transparent channel: Connect a serial device directly to the camera. The serial device will be
controlled remotely by the computer through the network.
Steps:
1. Enter RS-232 Port setting interface:
Configuration> Advanced Configuration> System > RS-232
2. Configure the Baud Rate, Data Bit, Stop Bit, Parity, Flow Control, and Usage.
If you want to connect the camera through RS-232 port, the parameters of the RS-232 should
be exactly the same with the parameters you configured here.
3. Click
RS-485
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ
parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS-485
to save the settings.
Figure 6-44 RS-232 Settings
to save the settings.
78
Advertisement
Table of Contents
